66
Troubleshooting
Model C602
General Troubleshooting (Cont ’d.)
PROBLEM CAUSE REMEDY
28. “Compressor on too long” fault
message.
a. Inadequate pump operation. a. Check pump operation. Assemble
pump according to instructions in
the operator’s manual.
b. Draw rate set too fast. b. Set the draw rate at 5 - 7-1/2 oz.
(142 213 g) of product per 10
seconds.
c. Inadequate air flow. c. Provide 3” (76 mm) air space
around sides.
d. Faulty blower baffle. d. Repair or replace blower baffle.
e. Inadequate AXV settings. e. Set AXV at proper setting. (See
“Running Specifications”.)
29. Symbol selection is delayed. a. Defective dec plate. a. Replace dec plate.
30. Erratic brush clean countdown
display.
a. The rectifier guard is not installed. a. Installed the guard to shield the
interface board from electrical
noise.
To Next Page
Loading...
