4
Introduction
Model C602
Model C602 Specifications
Freezing Cylinders
Shake Side: One, 7 quart (6.6 liter)
Soft Serve: One, 3.4 quart (3.2 liter)
Mix Hopper
Two, 20 quart (18.9 liter). Refrigerated to maintain
mix below 41°F (5°C).
Beater Motor
Shake: 1.0 HP
Soft Serve: 1.5 HP
Refrigeration System
Shake: 11,000 BTU/hr
Soft Serve: 9,500 BTU/hr
Refrigerant: R404A (BTU’s may vary depending on
compressor used.)
Main Compressor:
Air Cooled Units:
Shake: 54 oz (1,531 g) of R404A
Soft Serve: 46 oz (1,304 g) of R404A
Water Cooled Units:
Shake: 48 oz (1,361 g) of R404A
Soft Serve: 32 oz (907 g) of R404A
Note: Specifications are subject to change. Check
the data label for proper charging specifications.
Electrical
Standard is 208/230-60-3; however, other electrical
characteristics are available. Each unit requires
electrical service - Three Phase Maximum Fuse
Size: 40 A, Minimum Wire Ampacity: 36 A
Note: McDonald’s specifies Hubbell A460P9 plug
for 208-230/60-3 equipment.
Air Cooled
Clearance: A minimum of 3” (76 mm) is required
around all sides. Install the deflector provided to
prevent recirculation of warm air. Minimum air
clearances must be met to assure adequate air flow
for optimum performance.
Dimensions
Width: 25-1/4” (641 mm) including cup/cone
dispenser: 32- 3/8” (822 mm)
Height: 60- 7/16” (1535 mm)
Depth: 38- 7/8” (987 mm)
Floor Clearance: 4-3/4” (121 mm)
Approximate Weights
Net: 815 lbs. (369.7 kgs)
Crated: 1046 lbs. (474.5 kgs)
Volume: 66.5 cu ft (1.88 cu m)
Figure 1
To Next Page
Loading...
