13
Models C706 & C707
Introduction
AUTO Key
When the AUTO key is pressed, the light comes on.
This indicates that the main refrigeration system has
been activated. In the AUTO mode, the W ASH or
STANDBY functions are automatically cancelled. The
MIX REF function is automatically locked in to
maintain the mix in the mix hopper.
Note: An indicating light and an audible tone will
sound whenever a mode of operation has been
pressed. To cancel any function, press the key again.
The light and mode of operation will shut off.
Pump Key ( C706 Only)
When the PUMP key is pressed, the light comes on,
indicating the air/mix pump will operate as required.
Reset Button
The reset button is located on the side of the unit. The
reset protects the beater motor from an overload
condition. If an overload occurs, the reset mechanism
will trip. To properly reset the freezer , press the AUTO
key to cancel the cycle. Turn the power switch to the
OFF position. Press the reset button firmly.
Do not use metal objects to press the reset
button. Failure to follow this instruction may
result in electrocution.
T urn the power switch to the ON position. Press the
W ASH key and observe the freezer’s performance.
Open the side access panel. Make sure the beater
motor is turning the drive shaft in a clockwise direction
(from the operator end) without binding.
If the beater motor is turning properly, press the WASH
key to cancel the cycle. Press the AUTO key to resume
normal operation. If the freezer shuts down again,
contact a service technician.
Air/Mix Pump Reset Mechan ism
The reset button for the pump is located on the side of
the unit. This reset protects the pump from an overload
condition. Should an overload occur, the reset
mechanism will trip. To reset the pump, press the reset
button firmly.
Adjustable Draw Handle
The Model C706 and C707 feature an adjustable draw
handle to provide the best portion control. The draw
handle should be adjusted to provide a flow rate of 5
to 7-1/2 oz. of product per 10 seconds. To INCREASE
the flow rate, turn the screw CLOCKWISE. Turn the
screw COUNTER--CLOCKWISE to DECREASE the
flow rate. During “Sanitizing” and “Rinsing”, the flow
rate can be increased by removing the pivot pin and
placing the restrictive bar on the TOP. When drawing
product, always place the restrictive bar on the
bottom.
Figure 6
To Next Page
Loading...
