Taylor C706 - Page 9

6
Introduction
Models C706 & C707
Installation of Cone Dispenser (X48464)
The cone dispenser can be mounted to either the left
or right side of the machines. Two holes must be
created in the side of the machine.
1-1/8
(28.6)
24-1/4
(616.0)
9/32
(7.0)
1-5/8
(41.3)
9/32
(7.0)
Figure 2
The following components are contained in the
X48464 Cone Dispenser Kit:
DESCRIPTION PART NO. QTY.
DISPENSER A.--CONE--
DRAWER--DBL
X48465 1
SCREW--10--32X3/4OVALHD 001086 2
COLLAR--HOLDING 019481 2
NUTSERT--10--32 021106 2
INSTRUCTION --CONE
DISPENSER
048464--INS 2
NOTE: USE FIGURE 3 INSTEAD OF THE 048464--INS.
11/16
(17.5)
3/16
(5)
13/32
(10.3)
22-5/8
(575.7)
Use these slots for installation.
*
*
*
Figure 3