19
Model C707 Operating Procedures
140618
Step 5
Press the W ASH key. This will cause the sanitizing
solution in the freezing cylinder to agitate. Allow it to
agitate for five minutes.
Figure 27
Step 6
With an empty pail beneath the door spout, raise the
prime plug.
Figure 28
Step 7
When a steady stream of sanitizing solution is flowing
from the prime plug opening in the bottom of the
freezer door, pull the draw handle down. Draw off all of
the sanitizing solution.
Figure 29
Step 8
Once the sanitizer stops flowing from the door spout,
raise the draw handle. Press the WASH key, cancelling
the beater motor operation.
Figure 30
Note: Be sure your hands are clean and sanitized
before continuing these instructions.
Step 9
Lubricate the mix feed tube o- rings located on the end
of the tube with the small hole on the side. Stand the
mix feed tube in the corner of the mix hopper.
Figure 31
To Next Page
Loading...
Need help?
General
