OPERATING PROCEDURES
6-3
Model L850, L852, L858 Series
Operating Procedures
6
6. Allowing the cleaner to set softens any cooked-on
grease. Then use the blue handled angle tool to
scrub the entire grill surface.
See Figure 6-7
Figure 6-7
7. Use the squeegee to remove the cleaner and then
rinse all the areas with a wet white towel. Rinse the
towel as needed. Squeegee again if needed. Wipe all
surfaces with a clean dry white towel.
See Figure 6-8
Figure 6-8
8. Using Hi-Temp Cleaner and the blue handled angle
tool, apply the cleaner on the bottom and back of the
platen and grill surface. Allow the cleaner to have
contact for a few minutes. Then use the angled tool
to scrub the edges and back of the platen surface.
See Figure 6-9
Figure 6-9
9. Use the squeegee to remove the cleaner and rinse
all the areas with a wet white towel. Rinse the towel
as needed. When clean, wipe all surfaces with a
clean dry white towel.
See Figure 6-10 and 6-11.
Figure 6-10
Figure 6-11
To Next Page
Loading...