26
Models BC10/BW1 1Operating Procedures
080221
Step 15
Wipe clean all stainless steel surfaces with an
approved, non- abrasive commercial cleaner . This
includes the mixer, dispenser, and organizer surfaces.
W ARNING: Do not spray water or other
liquid around the motor chamber. Do not use
excess liquid around the switch, motor protector ,
power cords, or cord entry orifice. Make certain all
areas in and around the motor are dry before
connecting power to the wall receptacle. Failure to
comply may cause equipment damage or
personal injury due to electric shock.
Step 16
When foot pedal cleaning is required, disconnect it and
wipe it with a damp single service towel. Make sure the
foot pedal is thoroughly dry before re- connecting it to
the unit.
CAUTION: The foot pedal should be kept
dry. Do not leave it on the floor during mopping.
Failure to comply may result in electrical shock.
Permanent Agitator Cleaning
Step 1
Prepare a durable container with an approved
cleaning/sanitizing solution with an active chlorine
concentrate of 100 - 200 PPM (parts per million). USE
WARM WA TER (1 10_F/43_C) AND FOLLOW THE
MANUFACTURER’S SPECI FICATIONS. Do not use
a solution that contains ammonia.
Note: The container must be deep enough to
submerge the entire agitator and shaft.
Step 2
Submerge the agitator in the cleaning solution, all the
way to the bottom of the motor chamber. Activate the
agitator and alllow it to run for about 15 seconds.
Repeat this step several times, making certain all
portions of the agitator and shaft have been
submerged in the cleaning solution.
W ARNING: Never try to wipe clean the
agitator while it is active. Failure to follow these
instructions can lead to severe personal injury
from hazardous moving parts, or damage to the
unit.
Step 3
Repeat Step 2 using cool, clean water instead of
cleaning solution.
Sanitizing
Step 1
Repeat all steps of the cleaning procedure using an
approved cleaning/sanitizing solution with an active
chlorine concentrate of 100 - 200 PPM (parts per
million). USE WARM WATER (110_F/43_C) AND
FOLLOW THE MANUFACTURER’S SPECIFICA-
TIONS.
Step 2
Reinstall the splash guard.
Step 3
Repeat the sanitizing procedures at the start of the
day.
ALWAYS FOLLOW LOCAL HEALTH CODES
To Next Page
Loading...