Taylor Razzle BC10 - To the Operator; Warranty on Taylor Blenders

3
Models BC10/BW1 1 To the Operator
101021
Section 2 To the Operator
The mixer you have purchased has been carefully
engineered and manufactured to give you dependable
operation. Mixing various candies, cookies, fruits,
nuts, liquid flavors, and other food items into ice cream
or frozen yogurt has made unlimited flavor
combinations and product textures available.
The development of counter and wall mount mixers
have made this unlimited resource available to even
very small retail outlets and to those facilities where
counter space is limited.
The mixer, when properly operated and cared for, will
produce a consistent, quality product. Like all
mechanical products, it will require cleaning and
maintenance. A minimum amount of care and
attention is necessary if the operating procedures
outlined in this manual are followed closely.
This Operator’s Manual should be read
before operating or performing any maintenance on
your equipment. In the event that you should require
technical assistance, please contact your local
authorized Taylor Distributor .
Note: Warranty is valid only if the parts are authorized
Taylor parts, purchased from an authorized Taylor
Distributor, and the required service work is provided
by an authorized Taylor service technician. Taylor
reserves the right to deny warranty claims on
equipment or parts if non- approved parts or
refrigerant were installed in the machine, system
modifications were performed beyond factory
recommendations, or it is determined that the failure
was caused by neglect or abuse.
Note: Constant research results in steady
improvements; therefore, information in this
manual is subject to change without notice.
NSF approvals of the Models BC10 and BW11 were
obtained by the Vita- Mix Corporation, 8615 Usher
Road, Cleveland, Ohio 44138.
If the crossed out wheeled bin symbol is
affixed to this product, it signifies that this product is
compliant with the EU Directive as well as other similar
legislation in effect after August 13, 2005. Therefore,
it must be collected separately after its use is
completed, and cannot be disposed as unsorted
municipal waste.
The user is responsible for returning the product to the
appropriate collection facility, as specified by your local
code. For additional information regarding applicable
local laws, please contact the municipal facility and/or
local distributor .
Warranty o n Taylor Blenders
Caution: Warrantyisvalidonly if the parts are
authorized Taylor parts, purchased from an
authorized Taylor Distributor , and the required
service work is provided by an authorized Taylor
service technician.
W arranty Terms
This warranty covers only defects in material and
workmanship under normal use and service. The
Taylor Distributor will replace those components
that become defective as follows:
S One year warranty on parts and labor
from date of installation of blender.
Not included are the following items:
S External power cords and electrical
grounding.
S Wear items: agitator shaft, splash shield,
and foot pedal.
S Replacements required because of
operator misuse as defined below , fire or
other casualty, normal wear or
deterioration.
Misuse includes the owner’s failure to handle parts
properly, resulting in breakage. Misuse is also
defined as allowing unauthorized service agents
to attempt repairs on units.
For validation of warranty, this unit must be
registered at Taylor within thirty (30) days of
installation.