4
Models BC10/BW1 1Safety
130419
Section 3 Safety
Taylor is concerned about the safety of the operator
when he or she comes in contact with the blender and
its parts. Taylor has gone to extreme efforts to provide
built- in safety features to protect both you and the
service technician. As an example, warning labels
have been attached to the unit to further point out
safety precautions to the operator.
IMPORTANT - Failure to adhere to the
following safety precautions may result in severe
personal injury or death. Failure to comply with
these warnings may damage the machine and its
components. Component damage will result in
part replacement expense and service repair
expense. SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
To Operate Safely:
DO NOT operate the unit without reading
this operator’s manual. Failure to follow this instruction
may result in equipment damage, poor performance,
health hazards, or personal injury.
This appliance is to be used only by trained
personnel. It is not intended for use by children or
people with reduced physical, sensory, or mental
capabilities, or lack of experience and knowledge,
unless given supervision or instruction concerning the
use of the appliance by a person responsible for their
safety. Children should be supervised to ensure that
they do not play with the appliance.
This unit is provided with an equipotential
grounding lug that is to be properly attached to the rear
of the frame by the authorized installer . The installation
location is marked by the equipotential bonding
symbol (5021 of IEC 60417-1) on both the removable
panel and the frame.
DO NOT use a water jet to clean or rinse the
unit. Failure to follow these instructions may result in
serious electrical shock.
S DO NOT operate the unit unless it is properly
grounded.
S DO NOT operate the unit with larger fuses
than specified on the data label.
S All repairs must be performed by an
authorized Taylor service technician.
S The main power supplies to machine must be
disconnected prior to performing repairs.
S Cord Connected Units: Only Taylor authorized
service technicians or licensed electricians
may install a plug or replacement cord on
these units.
S DO NOT operate this appliance if the power
cord is damaged.
S DO NOT use this appliance outdoors.
S Stationary appliances which are not equipped
with a power cord and a plug or another device
to disconnect the appliance from the power
source must have an all-pole disconnecting
device with a contact gap of at least 3 mm
installed in the external installation.
S Appliances that are permanently connected to
fixed wiring and for which leakage currents
may exceed 10 mA, particularly when
disconnected or not used for long periods, or
during initial installation, shall have protective
devices such as a GFI, to protect against the
leakage of current, installed by the authorized
personnel to the local codes.
To Next Page
Loading...