25
Models BC10/BW1 1 Operating Procedures
080221
Daily Cleaning
Taylo r recommends d aily cleaning.
ALWAYS FOLLOW LOCAL HEALTH CODES
Step 1
Prepare a sink with an approved cleaning/sanitizing
solution with an active chlorine concentrate of 100 -
200 PPM (parts per million). USE W ARM WATER
(110_F/43_C) AND FOLLOW THE MANUFAC-
TURER’S SPECIFICATIONS. Do not use a solution
that contains ammonia and avoid placing components
in a dishwasher .
Note: Follow label directions, as too STRONG of a
solution can cause parts damage, while too MILD of a
solution will not provide adequate cleaning. Make sure
all brushes provided with the freezer are available for
brush cleaning.
Step 2
Disconnect power from the wall
receptacle. Failure to comply may result in
electrical shock.
Step 3
Remove the splash guard.
Wall mount units only (BW11): Remove the sliding
splash guard cup by squeezing the travel rods together
and sliding the guard downward. Take the cup to the
sink for cleaning.
Step 4
W ash the splash guard in the approved cleaning
solution.
Step 5
Using a single service towel moistened with the
cleaning solution, wipe clean the travel rods and the
agitator shaft.
CAUTION: DO NOT REMOVE THE TRAVEL RODS
FROM THE UNIT.
Step 6
Remove the dispenser from the bracket by tilting it
toward you and lifting upward.
Step 7
Discard any remaining topping.
Step 8
Remove the cover, shaft, dispensing plate, and
dispensing puck. Unscrew the handle from the
dispensing puck.
Step 9
Check all parts for cracks and damage, especially the
puck. Replace damaged parts immediately.
Step 10
W ash all plastic parts in the approved cleaning
solution. CAUTION: PLASTIC PARTS ARE NOT
DISHWASHER SAFE! HAND WASH ONLY!
Step 11
Re- assemble the dispenser. Make sure the
dispensing puck is placed in the canister with the
counterbore face down and the threaded insert facing
the slot.
Note: Parts must be dry prior to assembling and
refilling them with mix ingredients.
Step 12
Screw the handle through the slot and into the metal
insert in the dispensing puck. Place the dispensing
plate on top of the dispensing puck.
Step 13
Position the shaft through the plate and into the slot in
the dispensing puck. Make certain the shaft is properly
seated.
Step 14
Install the dispenser. Place the dispenser on the wall
bracket with the locating pin facing the holding bracket.
The dispenser must be tilted toward the operator to
clear the handle. Insert the pin into the hole in the
bracket.
Note: When loading the dispenser with product, keep
powder away from the top of the shaft. Fill the canister
only within one inch of the top. Do not overfill the
canister.
To Next Page
Loading...