EasyManua.ls Logo

Taylor Razzle BC10 - Page 9

Taylor Razzle BC10
37 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
Models BC10/BW1 1 Safety
130515
S Supply cords used with this unit shall be
oil-resistant, sheathed flexible cable not
lighter than ordinary polychloroprene or other
equivalent synthetic elastomer- sheathed
cord (Code designation 60245 IEC 57)
installed with the proper cord anchorage to
relieve conductors from strain, including
twisting, at the terminals and protect the
insulation of the conductors from abrasion.
If the supply cord is damaged, it must be
replaced by the manufacturer , its service
agent, or similarly qualified person, in order to
avoid a hazard.
Failure to follow these instructions may result in
electrocution. Contact your local authorized Taylor
Distributor for service.
S DO NOT allow children or untrained personnel
to operate this machine.
S DO NOT operate the unit unless all service
panels and access doors are restrained with
screws.
S AVOID contact with the agitator shaft and
other moving parts.
S Make sure the splash guard is installed prior
to operating the appliance.
S DO NOT disassemble or install parts unless
the On/Off switch is in the OFF position.
S If unit is equipped with a foot pedal, always
use the foot pedal guard. Avoid accidental use
of the foot pedal. When using the foot pedal,
make sure the appliance is located where
accidental contact with the pedal is not likely.
When the mixer is not in use, place the front
switch in the OFF position to avoid accidental
use of the pedal.
Failure to follow these instructions may result in severe
personal injury from hazardous moving parts.
DO NOT allow the power cord to hang over
the edge of the counter or touch hot surfaces. Failure
to comply may result in an electrical fire.
DO NOT operate this appliance if it
malfunctions or is damaged in any way. Failure to
follow this instruction may result in injury or component
damage.
Cleaning and sanitizing schedules are
governed by your Federal, State, or local regulatory
agencies and must be followed accordingly. Please
refer to the cleaning section of this manual for the
proper procedure to clean this unit.
DO NOT use attachments not recommended
or sold by Taylor. Doing so may cause fire, electric
shock, injury, or equipment damage.
Make sure the mixer is sitting or mounted
solidly on a sturdy surface during operation. Failure to
comply may result in injury or equipment damage.
Some consumers are highly allergic to
peanuts, peanut oil, and peanut dust. In
some severe cases, peanut allergy
reactions can cause death. When
blending product with peanuts, make
sure excess product is cleaned from the
agitator shaft to eliminate the fear of
product carryover.
WARNING!
NOISE LEVEL: Airborne noise emission does not
exceed 78 dB(A) when measured at a distance of 1.0
meter from the surface of the machine and at a height
of 1.6 meters from the floor.