Taylor SLIM7 - Section 9: Parts Replacement Schedule

Section 9
9-1
Model 0736
Parts Replacement Schedule
9
Parts Replacement Schedule
Maintenance Intervals
Table 9-1
*Call an authorized service techincian.
Part Description Every 3 Months Every 6 Months Annually Every 4 Years
Door Assembly X
Scraper Blades X
Beater Auger X
Beater Drive Shaft Seal X
Freezer Door O-Rings X
Draw Valve O-Ring X
Feed Tube O-Rings X
Pump O-Rings X
Duck Bill Valve X
Pump Rubber Valve X
Pump Gear Set X
*Mix Pump Actuator Belt X
*Glycol Fluid X
Brush-Drive Hub
Inspect and
replace if
necessary.
Minimum
Brush-Mix Inlet
Inspect and
replace if
necessary.
Minimum
Brush-Hopper
Inspect and
replace if
necessary.
Minimum