5
Ditto Looper in 30 seconds
Technical Specifications
Maximum loop length 5 minutes
Maximum no. of overdubs Unlimited
Bypass mode True Bypass
Latency None (analog dry-through)
Dimensions
(Width x Depth x Height)
48 x 48 x 93 mm /
1.9 x 1.9 x 3.7”
Input Connector Type Standard ¼” jack – mono/TS
Output Connector Type Standard ¼” jack – mono/TS
Power Input Standard 9 V DC,
centre negative (not supplied)
USB Connector Type Mini-B USB
Controls Loop Level knob
(Loop playback volume)
Switch
(Loop playback control)
Ditto Looper in 30 seconds
If you are in a hurry, chances are you’ll find what you’re looking
for on this page.
Operation
Power up Ditto Looper Connect a power supply.
Record Tap footswitch once.
Switch to playback Tap footswitch again.
Undo/Redo last recording Press and hold footswitch.
Stop Double-tap footswitch.
Stop and delete the loop Double-tap and hold footswitch.
Resume playback Tap footswitch again.
Delete the loop Press and hold footswitch
(when Ditto Looper is disengaged).
To Next Page
Loading...
