TC Electronic Flashback Triple Delay User Manual

Inputs, outputs and controls
Flashback Triple Delay English manual 2014-10-14 16
Power / Switching the
effect on and off
Power input
To power up your pedal, connect a power supply
to its power input socket.
The power input socket of your TC Electronic
effect pedal is a standard 5.5 / 2.1mm DC plug
(centre = negative).
Your TC Electronic effect pedal requires a 9 V
power supply providing 300 mA or more (sup-
plied). You may also use another 9 V or 12 V
power supply, as long as it provides 300 mA or
more.
To minimize hum, use a power supply with iso-
lated outputs.
Audio in and out
Audio inputs (stereo)
The audio inputs on the back of this pedal are
standard ¼” jacks (mono/TS).
►
If your signal source is mono, connect it to the
MONO in jack of the pedal.
►
If your signal source is stereo, connect the ca-
ble carrying the left signal component to the
MONO IN jack and the cable carrying the right
signal component to the STEREO IN jack.
Audio outputs (stereo)
The audio outputs on the back of this pedal are
standard ¼” jacks (mono/TS).
►
If the next device in the signal chain has
a mono input (e.g. your amp), connect the
MONO OUT jack of TC Electronic effect pedal
to the other device’s input.
►
If the next device in the signal chain has ste-
reo inputs (e.g. another stereo effect pedal),
connect the MONO OUT jack of your TC Elec-
tronic effect pedal to the left input and the
STEREO OUT jack to the right input of the
other device.

TC Electronic Flashback Triple Delay Specifications

General

Product type	Pedal
Product color	Blue
Built-in display	No
Manual	Yes

Weight and Dimensions

Depth	145 mm
Width	235 mm
Height	57 mm