TC Electronic Flashback Triple Delay User Manual

Inputs, outputs and controls
Flashback Triple Delay English manual 2014-10-14 18
Resetting parameters and
parameter ranges
To reset the parameters and parameter ranges
assigned to a preset, proceed as follows:
►
Connect an expression pedal to the Exp
Pedal jack.
►
Switch on the delay.
►
Choose a Delay Engine (1, 2 or 3) using the
Delay 1/2/3 selector switch. Make sure that
this Delay Engine is active – its footswitch
should be lit.
►
Set the expression pedal to the maximum
position.
►
Press and hold the footswitch for the preset.
USB port
Use the standard Mini-B USB port on your TC
Electronic effect pedal to connect your pedal to
a computer. This will allow you to load TonePrints
into the pedal or create your own TonePrint us-
ing TC’s TonePrint Editor. For more information,
see “TonePrint”.
If there are firmware updates for this pedal, they
can also be installed using the USB port – see
“Updating the firmware”.
MIDI IN / MIDI THRU jacks
These are standard MIDI (Musical Instrument
Digital Interface) connectors.
MIDI In jack
Connect a computer/DAW (or another device
generating a MIDI Clock signal) to the MIDI IN
jack to control the pedal’s delay tempo.
An incoming MIDI Clock signal will override the
settings of the pedal’s own Delay Time knob.
However, the Subdivision Selector knob still de-
fines the actual note values used to generate the
delays.
This delay unit is receiving MIDI messages on
MIDI channel 1.

TC Electronic Flashback Triple Delay Specifications

General

Product type	Pedal
Product color	Blue
Built-in display	No
Manual	Yes

Weight and Dimensions

Depth	145 mm
Width	235 mm
Height	57 mm