TC Electronic Flashback Triple Delay User Manual

Inputs, outputs and controls
Flashback Triple Delay English manual 2014-10-14 22
SUBDIV knob – Subdivision
selector knob
Use the Subdiv knob to choose the note intervals
that the delay repetitions are based on. Choose
from the following values:
►
Dotted quarter notes
►
Quarter notes
►
Quarter note triplets
►
Dotted eighth notes
►
Eighth notes
►
Eighth note triplets
►
Sixteenth notes
►
Dual Delay: Quarter notes and eighth notes
►
Dual Delay: Quarter notes and dotted eighth
notes
►
Dual Delay: Dotted eight notes and eighth
notes
►
Dual Delay: Dotted eight notes and sixteenth
notes
Delay Engine/Preset footswitches (1/2/3)
Use the three Delay Engine footswitches (1, 2
and 3) to switch the three Delay Engines of the
Flashback Triple Delay on and off. The three De-
lay Engines can be activated separately. If an En-
gine is on, its LED is lit.
Switching a Delay Engine off and on again will
also recall the Preset stored for this Engine. This
means that when you…
►
change the settings for a Delay Engine with-
out storing them,
►
switch the Delay Engine off and
►
switch it on again,
you will hear the previously stored settings for
this Delay Engine. For more information, see
“Storing presets”.
Preset off / Bypass mode
When none of the three footswitch LEDs are lit,
the pedal is in bypass mode, and you will only
hear the dry, unprocessed signal.
If you have set the internal Kill-Dry dip switch to
the “On” position (see“Kill-dry on/off”), and none
of the three footswitch LEDs are lit, no signal will
be present at the output.

TC Electronic Flashback Triple Delay Specifications

General

Product type	Pedal
Product color	Blue
Built-in display	No
Manual	Yes

Weight and Dimensions

Depth	145 mm
Width	235 mm
Height	57 mm