Need help?Do you have a question about the TC Electronic FLASHBACK X4 and is the answer not in the manual?
General| Looper | Yes (40 seconds) |
|---|---|
| Presets | 3 |
| Tap Tempo | Yes |
| MIDI | Yes |
| TonePrint | Yes |
| Current Draw | 300 mA |
| Type | Delay |
| Inputs | 2 x 1/4" |
| Outputs | 2 x 1/4" |
| Power Source | 9V DC |
| Delay Types | 2290, Analog, Tape |
| True Bypass | Yes (switchable to buffered) |
Safety precautions to reduce risk of fire or electrical shock.
All servicing must be performed by qualified personnel.
Modifications not approved may void operating authority.
Instructions for connecting mono or stereo signal sources.
Instructions for connecting mono or stereo outputs.
Specifies the recommended type of expression pedal.
How to map pedal parameters to an expression pedal.
Connects to computers or devices for MIDI clock signal.
Forwards incoming MIDI signals to other devices.
Details on TonePrint slots and default settings.
Steps to load TonePrints onto the pedal using a USB cable.
Method for transferring TonePrints using the TonePrint App.
How to activate and select stored presets.
Details on the three default presets included with the pedal.
Describes the pedal's bypass state when no preset is active.
How delay effects interact with the looper functionality.
Steps to initiate and stop loop recording.
Methods for stopping loop playback immediately or at cycle end.
How to trigger a single playback of a recorded loop.
How to undo or redo recordings for creative or error correction.
Procedure to completely erase the current loop recording.
Note that loops are erased when the pedal is powered off.
Explains the hard-wire bypass for unaffected tone.
Describes bypass mode for longer signal chains.
To Next Page