11
Expression pedal input continued
Resetting parameters and parameter ranges
To reset the parameters and parameter ranges assigned to a Flash-
back X4 Delay & Looper preset, proceed as follows:
– Connect an expression pedal to the EXP PEDAL jack on the
Flashback X4 Delay & Looper.
– Switch on the Flashback X4 Delay & Looper.
– Choose the respective preset (A, B or C) on the Flashback X4
Delay & Looper.
– Set the expression pedal to the maximum position.
– Press and hold the footswitch for the preset.
– Set the knobs for the parameters you want to control to the
desired maximum values.
– Set the expression pedal to the minimum position.
– Set the knobs for the parameters you want to control to the
desired minimum values.
– Press and hold the footswitch for the preset to store these
settings.
To Next Page
Loading...
