26
The Looper module continued
Loops cannot be stored
Please note that while you can store the delay module’s settings as
presets, you cannot store loops. When you switch off the Flashback
X4 Delay & Looper, the current loop is erased.
Undoing a loop recording
During loop recording, each new recording is added on top of the
loop’s previous version. However, if you make a mistake during
a recording cycle, you can undo it by pressing the UNDO/REDO
footswitch.
If you change your mind, you can press the UNDO/REDO foot-
switch again to bring back the previously deleted recording cycle.
The undo/redo feature is not only useful for fixing mistakes – it can
also be used as a creative tool on stage. Here is a simple example:
– Record a bass line (loop cycle 1)
– Record some chords (loop cycle 2)
– Record a melody (loop cycle 3)
– Tap the UNDO/REDO footswitch to remove the melody. Sing
or improvise.
– Tap the UNDO/REDO footswitch again to bring back the previ-
ously recorded melody.
Deleting a loop completely
To delete your loop recording (not only the last recording cycle)
completely, press and hold the UNDO/REDO footswitch.
To Next Page
Loading...
