TC Electronic FLASHBACK X4 User Manual

20
Presets
13 – Preset footswitches (A / B / C)
13
When the LOOPER/DELAY switch (see page 18) is in the bottom
position (“Delay”), the three switches A, B and C can be used to
access the Flashback X4 Delay & Looper’s three presets.
When the LOOPER/DELAY switch is in the top position (“Looper”),
you do not have access to presets. Instead, the current positions
of the delay knobs apply (see page 24).
Recalling a preset
Press the footswitch corresponding to the preset you want to
recall (use). Only one preset can be active at a time.
The LED of the active preset’s footswitch will be lit.
Factory presets
The Flashback X4 Delay & Looper comes with three factory pre-
sets, but you can overwrite them with your own favorite settings.
A This is an Eric Johnson-style tape echo with somewhere be-
tween 2 and 3 repeats.
B This is a swirly and big 2290 delay with modulation on the re-
peats. Great for clean playing and volume swells – or if you’re
into U2…
C This is a short analog delay that will give your sound a bit more
ambience.
Preset off / Bypass mode
When none of the three footswitch LEDs are lit, the pedal is in
bypass mode, and you will only hear the dry, unprocessed signal.
If you have set the internal Kill-Dry dip switch to the “On” posi-
tion (see page 28) and none of the three footswitch LEDs are
lit, no signal will be present at the Flashback X4 Delay & Looper’s
output.

TC Electronic FLASHBACK X4 Specifications

General

Looper	Yes (40 seconds)
Presets	3
Tap Tempo	Yes
MIDI	Yes
TonePrint	Yes
Current Draw	300 mA
Type	Delay
Inputs	2 x 1/4"
Outputs	2 x 1/4"
Power Source	9V DC
Delay Types	2290, Analog, Tape
True Bypass	Yes (switchable to buffered)