TC Electronic G-Force Service Manual

______________________________________________________________________________________________________________________________________________________________________________
_________________
TC Electronic A/S
G
-
Force
Service manual
page
10
Exchange of Battery Exchange procedure
Recommended battery type: CR2032-FT-4-2.
TC stock no. (TCcode) for battery: 342 0000 11
1. Turn Off Power and Disconnect Power Cord.
2. Loosen 5 screws, see fig. 1, and remove the top cover.
3. Desolder the old battery by warming up each terminal one by one. Avoid any
short circuit of the terminals. Be careful not to damage the wiring on the board.
4. Insert new battery and solder the terminals one by one. Avoid any short circuit of
the terminals.
5. The voltage measured directly across the terminals of the new battery should
be higher than 3.0VDC.
6. Do not discard the old battery. Hand it over to a recycling company or your dealer.
CAUTION:
DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE
ONLY WITH SAME OR EQUIVALENT TYPE RECOMMENDED BY THE
MANUFACTURER. DISCARD USED BATTERIES ACCORDING TO THE
MANUFACTURERS INSTRUCTIONS.
VARNING:
Felaktigt batteribyte kan medfora fara for explosion. Anvand darfor endast samma
typ eller likvardig typ enligt apparattillverkarens rekommendation.
Kassera forbrukade batterier enligt tillverkarens anvisning
ADVARSEL:
Lithiumbatteri. Eksplosionsfare ved fejlagtig håndtering. Må kun udskiftes med
batteri af samme fabrikat og type.
Lever det brugte batteri tilbage til leverandøren.

TC Electronic G-Force Specifications

General

Brand	TC Electronic
Model	G-Force
Category	Recording Equipment
Language	English