TC-Helicon GO XLR User Manual

27 GO XLR User Manual
11.4 Assigning Custom Colors for Eects
Similarly, you may also assign custom colors to the buttons and knobs in the GO XLR Eects section, with separate sets of color options for Presets, Encoders and
buttons for Eects, including the Megaphone, Robot, Hardtune and FX buttons.
Eects lighting options
Each section also has the “Apply To All” option available if you want identical color schemes for all Presets buttons or for all encoder knobs.
11. 5 Encoder Colors
The Encoder knobs have special color assignment options that allow you to assign
separate colors on either of the white indicator that shows exactly where the
encoder knob is set. For example, you could assign all LEDs to the left of the white
indicator to shine red, while to the left the LEDs are blue.
Color options for Encoder knobs
These diering color assignments are handy if you wish to know at-a-glance
where the eects encoders are set.
Reverb encoder knob with blue to the left of the white indicator
You may also set the LEDs inside the encoder knobs to shine with a custom color
by selecting a color under the Knob Color section.
Knob Color with custom color assignment

TC-Helicon GO XLR Specifications

General

Frequency range	10 - 20000 Hz
Channels quantity	- channels
Supported sample rates	48 kHz
Digital sound processing	24 bit
Line Signal-to-Noise Ratio (SNR)	101 dB
Equalizer bands quantity	4
Headphone connectivity	3.5 mm
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Number of microphone inputs	1
DJ mixer	-
Product color	Black
USB connector type	USB Type-B
Fuse	1 A
Phantom power	48 V
Power consumption (typical)	10 W

Weight and Dimensions

Depth	174 mm
Width	285 mm
Height	82 mm
Weight	1550 g