Need help?Do you have a question about the TC-Helicon Harmony GXT and is the answer not in the manual?
General| Brand | TC-Helicon |
|---|---|
| Model | Harmony GXT |
| Category | Recording Equipment |
| Language | English |
Step 1: Connect your microphone to a standard mic cable.
Step 2: Connect the mic cable to the Harmony-G XT's Mic Input.
Step 3: Connect the Left (mono) Out to a mic input on your sound system.
Step 4: Connect your guitar to the INST IN jack.
Step 5: Set the Input knob fully left and other controls to 12 O'Clock.
Step 6: Connect the power adapter to the unit and main power.
Step 7: Raise Input knob until LED is green, not red.
Step 8: Verify LEDs conform to the status shown in the manual.
Step 9: Raise mixer fader, tune guitar using the Tuner/Bypass mode.
Adjusts input level and indicates signal status.
Engages adaptive Live Engineer Effects and Auto-Chromatic Pitch Correction.
Controls guitar volume routed to main outputs when THRU is unused.
Raises or lowers the mix level of the selected effect.
Cycles through presets and holds to store changes.
Toggles between favorite presets or enters preset select mode.
Engages/disengages doubling/harmony effects or enters Tuner/Bypass mode.
How to activate and hear harmony voices by pressing the On footswitch.
Engaging Tuner/Bypass mode to tune guitar strings.
Resetting all presets and settings to factory defaults.
Common issues and solutions when harmonies don't respond to guitar input.
Steps to take if the guitar signal is not audible.
Diagnosing why the sound is dry despite FX being active.
Solutions for VoiceSupport failing to connect to the Harmony-G XT.
To Next Page