Changing the FX
Press the FX button to change the reverb and delay
style in the preset you are currently on. If you prefer this
setting, it can be stored with the preset.
Using the Tuner
Hold the On footswitch to enter Tuner/Bypass mode.
The On led will flash. Pluck the single open string you
want to tune and you’ll see the note it’s closest to in the
Preset display. As well, a pattern of LEDs in the FX styles
and Voice 1&2 indicator areas will show whether the
string is sharp or flat. As you raise or lower the pitch of
the string, the FX and Voice 1/ Voice 2 indicator LEDs will
light as shown.
Shows string is in tune
To Next Page
Loading...
Need help?
General
