24
SET + Preset 3: Mic Control
Holding down the SET button and pressing Preset 3 repeatedly will
cycle through Mic Control settings, with the VU meter LED showing
which mode you’re in.
RED: Mic Control Off
Use this when you have a condenser microphone. If you have another Mic Control mode set, you may
inadvertently activate buttons on the box as you sing.
GREEN: MP-75 Mode
On your TC-Helicon MP-75 Microphone, the single Mic Control button cycles the
preset selection. You can reassign the Mic Control button by holding the button
and then pressing the corresponding button on Perform-VE that you’d like to
control.
For example, if you hold the Mic Control then press the Reverb button, the MP-75
will now toggle Reverb on and off.
YELLOW: MP-76 Mode
In MP-76 mode, the Mic Control button cycles the preset selection as it does in
MP-75 mode. The remaining three buttons default to toggle the following effects
on your Perform-VE:
• Left toggles ECHO.
• Right toggles FILTER.
• Bottom toggles XFX.
NOTE: If you have a TC-Helicon MP-76 connected but choose MP-75 mode instead,
the lower three buttons will not operate.
The MP-75 and MP-76 buttons can be reassigned to control the following:
• DOUBLE
• MORPH
• HARDTUNE
• XFX
• ECHO
• FILTER
• LOOPER Record/Play/Erase
• SAMPLE record
• SAMPLE play
• Preset 1
• Preset 2
• Preset 3
• Tap Tempo
To Next Page
Loading...
