• Flashing blue light: WPS connection is available.
• Steady blue light: Wi-Fi is enabled.
• Off: Wi-Fi is deactivated.
3.Wi-Fi/WPS indicator light
• Steady blue light: The device is on.
• Flashing blue light: The device is updating firmware through FOTA.
• Off: The device is off.
4. Power indicator light
• Press and hold for 3 seconds to power off the unit.
• Press and hold for 1 second to power on the device.
5. Power button
Press the button for 3 seconds to enable the WPS function. If the WPS connection is not established within
2 minutes, the WPS function will automatically fail.
6.WPS button
7.WAN/LAN port For connecting to an Internet source or wired device, such as a computer or switch.
8. Local domain port For connecting to wired devices such as computers or switches.
9. Telephone port Connect a phone to make or receive calls.
10. Power connector For connecting the power transformer.
Things to note
You can see the power indicator flashing blue while the CPE downloads and installs software updates. Do not power
off the CPE during this process as this may cause unit failure.
1
2
3
1. Micro USB port It is for debugging purposes only.
2.Nano SIM card slot Insert the Nano SIM card into the slot.
3. Reset button Press and hold the button with a paper clip for 3 seconds to reset the device.
2