TCL iQool-2MS9K9K - Energy Saving and Protection Tips

4
 Do not clean the unit by spraying it or immersing it in water.
 Any service other than regular cleaning or filter replacement should be performed by an
authorized service representative or a qualified air conditioning engineer. Failure to
comply could result in a voided warranty.
 This air conditioner is intended for cooling / heating a room to a suitable level for
human comfort, and should not be used for any other purpose such as cooling food.
 Avoid restarting the air conditioning unit unless 3 minutes have passed since being
turned off. This prevents damage to the compressor.
 Never use the mains as a switch to start and turn off the air conditioning unit. Use the
provided ON/OFF button located on the remote control.
 The indoor unit should not be installed in laundry or wet rooms.
 Diagrams and pictures provided within the manual are for guidance only. Due to
continual product development, if there is any variance between the manual and the
product received, the information provided on the product should be followed.
ENERGY SAVING AND UNIT SAFETY PROTECTION TIPS
 Do not cover or restrict the airflow from the outlet or inlet grills.
 For maximum performance the minimum distance from a wall or objects should be 50cm.
 Keep the filters clean. Under normal conditions, filters should only need cleaning once every
four weeks (approximately). Since the filters remove airborne particles, more frequent cleaning
maybe necessary, depending on the air quality.
 For the initial startup set the fan speed to maximum and the thermostat to 4-5 degrees lower
than the current temperature. After, set the fan switch to low and set the thermostat to your
desired setting.
 To protect the unit we recommend not using the cooling mode when the ambient indoor
temperature is higher than 35℃.
 To protect the unit we recommend not using the heating mode when the indoor ambient
temperature is lower than 7℃. Performance will be reduced at lower temperatures.
 Note the manufacturer operating temperature ranges at the end of this user manual.