TCL TAC-24CHSC

2. Tools required
2.1 Tools
Screw driver Hand drill Ruler, knife Gas leak detector
& soup water
Thermometer Hex. wrench
(Large side: 4mm, 5mm)
Assembly,
disassmbly
Indoor installation
plate fixing
Ruler: Length &
distance
measurement.
Knife: Tape cutting
Leak inspection
Temperature
measurement at
Indoor suction
inlet/discharge outlet.
Service valve
operating
Core drill
(diameter 70mm)
Monkey spanner
(300mm): 2EA
Torque wrench Hook meter
(for current measurement)
Insulation
resistance meter
Flare tool set
Connnection cable Winter cover Anti-vibration
rubber
Band Adhesive Drain hose
Refrigerant pipe
(for high/low pressure)
Putty Vinyl tape Remocon fixture Fixture clamping
screw
Remocon
Refrigerant circuit
connection to
Indoor/Outdoor.
Chaging of wall-
through hole
Wire & pipe
finishing
Remocon hanger Remocon fixture
fixing
Indoor-Outdoor
wire connnection
Outdoor protection
in a unusedseason
like winter
Vibration absorption
of outdoor
Wire & pipe
finishing
Finishing Drainage
Wall through Indoor/Outdoor
pipe connection
Indoor/outdoor
pipe connection
Current, voltage,
resistance
measurement
Insulation resistance
measurement
(Electric shock prevention)
Pipe cutting,
Burr removal
Level
Clamp meter
Thermometer
Drive torch Mega tester
2.2 Accessory
TCL Air Conditioner Service Manual
3
Remark: Some of the above parts are provided by the installer and not included in the standard air-conditioner.