To Next PageTo Next Page
Need help?Do you have a question about the TCL TAC-12CHSA and is the answer not in the manual?
General| Capacity | 1 Ton |
|---|---|
| Power Supply | 220-240V, 50Hz |
| Type | Split Air Conditioner |
| Functions | Cooling |
| Operating Temperature (Cooling) | 18°C to 43°C |
| Cooling Capacity | 12000 BTU/h |
Instructions for ordering replacement parts, including required information like model number and part name.
Explanation of the remote controller buttons and their functions for operating the air conditioner.
Details safety controls like time delay, frost prevention, and high-temperature protection for the electronic system.
Explains how the "I Feel" mode adjusts operation based on room temperature and set point.
Describes the system's operation when the COOLING mode is selected, including default settings.
Details the operation of the DRY mode, including its refrigerant cycle and cooling behavior.
Explains the HEATING mode, its automatic settings, and operation, specifically for Heat Pump models.
Explains the defrosting control and termination conditions based on indoor pipe temperature and compressor operation time.
Describes the operation of the FAN mode, where the indoor fan runs continuously at the set speed.
Details the function and timing of the 4-way valve's reversal before compressor startup for mode switching.
Explains the SLEEP mode settings, including fan speed, temperature adjustments, and automatic shutdown after 8 hours.
Covers rotational frequency feedback control for the indoor fan motor and detection of lock-up conditions.
Explains automatic control of indoor fan speed based on room temperature and set temperature in Cooling and Heating modes.
Describes the vane motor drive, positioning, and automatic/swing mode operations for airflow direction.
Details how to activate the air conditioner at a desired time using the remote control, including mode, temperature, and fan speed selection.
Explains how to use the emergency switch on the indoor unit for operation when the remote is unavailable or faulty.
Describes how to set the AUTO RESTART function, which resumes operation after a power failure based on memorized settings.
Details how to interpret failure codes displayed on the unit and provides basic handling procedures for sensor or motor failures.
