To Next PageTo Next Page
Need help?Do you have a question about the TCL TAC-12CSA and is the answer not in the manual?
General| Capacity | 1 Ton |
|---|---|
| Power Supply | 220-240V, 50Hz |
| Type | Split |
| Operating Temperature (Cooling) | 18°C to 43°C |
| Cooling Capacity | 12000 BTU/h |
Instructions for ordering replacement parts, including required information.
Description of the remote controller and its primary buttons.
Details safety mechanisms like compressor delay and frost prevention.
Explains the 'I Feel' mode operation and temperature setting logic.
Describes the system's behavior when the cooling mode is selected.
Details the operation of the DRY mode, including initial settings.
Explains HEATING mode operation for heat pump models.
Specifies conditions for initiating and terminating defrost cycles.
Describes the operation when the FAN mode is selected.
Explains the function and timing of the 4-way valve.
Details how the SLEEP mode adjusts fan speed and temperature.
Covers rotational frequency feedback and lock-up detection for fan motors.
Explains automatic fan speed adjustment based on temperature.
Describes vane motor control, positioning, and modes.
Instructions for setting timer functions on the remote control.
Procedure for operating the unit using the emergency switch.
Details how to set and cancel the auto restart feature.
Information on fault codes and troubleshooting steps.
Lists specific failure codes (E1, E2, E6) and their causes.
Describes system responses and actions for specific failures.
Explains the meaning of indicator lamps on the control board.
