To Next PageTo Next Page
Need help?Do you have a question about the TCL TAC-12CS and is the answer not in the manual?
General| Type | Split Air Conditioner |
|---|---|
| Cooling Capacity | 12000 BTU/h |
| Refrigerant | R410A |
| Compressor Type | Rotary |
| Power Supply | 220-240V, 50Hz |
Steps and information needed for ordering replacement parts.
Measurements and diagrams for the indoor air conditioner unit.
Measurements and diagrams for the outdoor air conditioner unit.
Illustrates the refrigerant flow for heat pump operation.
Illustrates the refrigerant flow for cooling-only operation.
Information on the maximum allowable vertical distance between units.
Step-by-step guide for evacuating the refrigerant circuit.
Specifies operating voltage range and air flow settings.
Graphs showing pressure and current under cooling conditions.
Graphs showing outdoor unit current during heating.
Explanation of the remote control buttons and their operations.
Guide on setting the remote for Cooling Only or Heat Pump.
Details on compressor delays, frost prevention, and overheat protection.
Explains how the "I Feel" mode adjusts settings based on room temperature.
Details the system's behavior when the COOLING mode is selected.
Checks for working power, voltage drop, and wire capacity.
Inspects insulation resistance and component checks.
Analyzes evaporator suction/discharge air temp difference and running current.
Analyzes refrigerant pressures and temperatures for diagnosis.
Lists common refrigerant issues and corresponding corrective steps.
Verifies power input and voltage output for system operation.
Diagnoses issues preventing the room fan from operating.
Diagnoses issues with compressor or outdoor fan operation.
Diagnoses issues with the up/down vane movement.
Diagnoses issues with the left/right louver movement.
Troubleshoots issues with remote control function settings.
Troubleshoots problems with switching between cooling and heating modes.
Instructions for installing wall-mounted split type air conditioners.
Lists necessary tools for air conditioner installation.
Steps for selecting locations and installing indoor/outdoor units.
Detailed procedures for pipe cutting, flaring, and connecting.
