TDK-Lambda GENESYS 750W HALF RACK - Page 11

83
-
507
-
5002 Rev. B
3
SAFETY INSTRUCTIONS
ENVIRONMENTAL CONDITIONS
The Genesys
TM
power supply series safety approval applies to the following operating cond
i
tions:
*Indoor use
*Ambien
t temperature: 0°C to 50°C
*Maximum relative humidity: 90% (no condensation)
*Altitude: up to 3000m
*Pollution degree 2
CAUTION Risk of Electrical Shock
Instruction manual symbol. The instrument will be marked with this symbol when it is
necessa
ry for the user to refer to the instruction manual.
Indicates hazardous voltage.
Indicates ground terminal.
Protective Ground Conductor Terminal
Off (Supply)
On (Supply)
The WARNING sign denotes a hazard. An attention to a procedure is
called. Not fo
l-
lo
w
ing procedure correctly could result in personal injury.
A WARNING sign should not be skipped and all indicated conditions must be
fully understood and met.
The CAUTION sign denotes a hazard. An atten
tion to a procedure is called. Not follo
w-
ing procedure correctly could result in damage to the equipment. Do not proceed b
e-
yond a CAUTION sign until all indicated conditions are fully understood and met.
FCC COMPLIANCE NOTICE:
Note: This equipment has be
en tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pr
o-
vide reasonable protection against harmful interference when the equipment is operated
in a commercial environ
ment. This equipment generates electro
-
magnetic field, and can
radiate radio frequency energy and, if not installed and used in accordance with the i
n-
struction manual, may cause harmful interference to radio communications. Operation
of this equipment in a
residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.