TDK-Lambda GENESYS 750W HALF RACK - Page 8

83-507-5002 Rev. B
TABLE OF CONTENTS
7.10.4 Addressed commands with response……………………………………………………
Pg. 60
7.10.5 Addressed commands without response………………………………………………..
Pg. 61
7.10.6 Status Control Commands………………………………………………………………..
Pg. 6
3
7.11 STATUS, ERROR AND SRQ REGISTERS……………………………………………….…..
Pg. 63
7.11.1 General Description………………………………………………………………….…….
Pg. 63
7.11.2 Conditional registers………………………………………………………………….……
Pg. 64
7.11.3 Service Request Enabled and Even
t Registers………………………………….……..
Pg. 65
7.12 SERIAL COMMUNICATION TEST SET
-
UP…………………………………………….…….
Pg. 68
CHAPTER 8 ISOLATED ANALOG PROGAMMING OPTION
……………………………..…….
Pg. 69
8.1 INTRODUCTION……………………………………………………………………………………
Pg. 69
8.2 SPECIFICATIONS…………
……………………………………………………………………….
Pg. 69
8.2.1 0
-
5V/0
-
10V o
p
tion (PN:IS510)………………………………………………………...……
Pg. 69
8.2.2 4
-
20mA option (PN: IS420)………………………………………………………….……..
Pg. 69
8.3 ISOLATED PROGRAMMING & MONITORING CONNECTOR………………………………
Pg. 70
8.4
SETUP AND OPERATING INSTRUCTIONS……………………………………………………
Pg. 71
8.4.1 Setting up the power supply for 0
-
5V/0
-
10V Isolated Programming and Monito
r
ing…
Pg. 71
8.4.2 Setting up the power supply for 4
-
20mA Isolated Programming and Monitoring……..
Pg.
71
CHAPTER 9 MAINTENANCE………………………………………………………………………...
Pg. 72
9.1 INTRODUCTION……………………………………………………………………………………
Pg. 72
9.2 UNITS UNDER WARRANTY……………………………………………………………………...
Pg. 72
9.3 PERIODIC MAINTENANCE……………………………………………………………………….
P
g. 72
9.4 ADJUSTMENT AND CALIBRATION……………………………………………………………..
Pg. 72
9.5 PARTS REPLACEMENT AND REPAIRS………………………………………………………..
Pg. 72
9.6 TROUBLESHOOTING……………………………………………………………………………..
Pg. 72
9.7 FUSE RATING……………………………………………………………………………………...
Pg. 74