Teac A-3300SX - Partial Dis-Assembly

4-2 HEAD ASSEMBLY REMOVAL
AWD
. Note the positions of the wires on the circuit board.
. Unsolder the wires.
. Remove the 2 mounting screws, replace the assembly.
. Solder the wires of the new assembly in exactly the same
4, PARTIAL DIS-ASSEMBLY
4-1
REMOVING
WOODEN
SIDES
Unsolder
Wires
Here
AND
REAR
PANEL
See illustration for complete dis-assembly instructions.
Most amplifier checks and adjustments can be made from
the bottom with the (bottom) panel removed.
These adjustments should be performed by experienced
technicians, and then only when going through the com-
plete test and check procedures on the unit which is being
tested.
' Fig. 4-2 Head Ass’y Removal
HM
Cry. Hyg
a
6||
gg
Hy
ot
4-3 REMOVAL OF CAPSTAN MOTOR
1. Remove the 3 screws (a) holding the capstan motor
Plate.
2. Unsolder the 6 wires connecting the capstan motor.
3. Remove the 4 screws holding the capstan motor to the
motor plate. Watch for the Rubber Cushions.
4. Loosen the 2 set screws (hex head) in pulley and lift off
is pulley. Loosen 2 set screws in fan and remove fan.
AN
A
z
AW
NOTE: USA, CANADA versions of the A-3300SX/
sl. A-2300SX have a different pulley than that shown
and have no Frequency Selector switch. See page
13, Section VOLTAGE AND FREQUENCY
CONVERSION.
A
A
WU
V
8
==
a
»
oO of woe
awh
WIS
AKI
Ny
Fig. 4-1 Removing Wooden Sides and Rear and Bottom Panels
4 DS
on Frquency selector SW
To
change
the
head
assembly
as
a
unit,
ie
only}
positions.
NOTE: See page 10, HEAD REPLACEMENT AND ALIGN-
MENT Section for more detailed explanation.
Fig. 4.3 Capstan Motor Removal