Teac A-6300 - Parts Ordering Information

PARTS ORDERING INFORMATION
Replacement parts are available through your nearest TEAC Authorized
Service Center or directly from the TEAC office, the address of vdiich
is written on the back cover.
Changes are constantly being made to make TEAC products better and more
reliable.
Therefore, when ordering parts, always include the following information:
1. MODEL
2. FIG.REF.NO.
3. TEAC PARTS NO
4. DESCRIPTION
5. UNIT SERIAL NO
6 . MANUAL CODE NO
NOTICE REGARDING PARTS ORDERS
1. The Schematic Diagram Circuit Reference Numbers should not be used
for ordering parts. Use of those numbers will result in confusion
and might bring you the wrong part. To insure the correct part from
your order, always use the TEAC PARTS NUMBER and include all infor¬
mation as requested above.
2. To insure rapid parts identification and thus rapid delivery of the
part you desire, always include the MANUAL CODE NUMBER with each
part or group of parts from a specific manual. This Manual Code
Number is printed on the lower right-hand corner of the Parts List
Manual, front page.
3. In some instances, individual minor parts are not available.
In such a case, the entire assembly including the part requested will
be sent to you.
MARKET MODEL IDENTIFICATION ABBREVIATIONS
DM: For only domestic (Japan) market decks.
EX: For all export versions (except TCA or Japan).
TCA: For TCA (TEAC Corporation of America, U.S.A.)
versions only.
- 4 -