Teac AG-10D - Preset Station Management; Manual Station Presetting; Selecting and Scanning Preset Stations

ENGLISH
Preset Tuning
2
74
You can store up to 30 stations.
Manual Memory Presetting
Tune in a station you want to listen to (see steps to of
page 72).
Press the MEMORY button.
While the "MEMORY" indicator is blinking, select a preset
channel to store the station using the TUNING/PRESET
buttons (or the PRESET buttons of the remote control unit), and
then press the MEMORY button.
To store more stations, repeat steps to .
31
3
2
411
MEMORY TUNINIG/
PRESET
TUNING MODE
3
Scanning preset stations
Press the P.SCAN button of the remote control unit. Preset
stations stored in memory are scanned at 5 seconds intervals.
When the station you want to listen to is found, press the
P.SCAN button again to stop scanning.
How to select preset stations
If "PRESET" indicator isn't lit, press the TUNING MODE button
to select the preset tuning mode.
<
When using the remote control unit, you can skip this step.
Press the TUNING/PRESET buttons (or the PRESET buttons of
the remote control unit) repeatedly until the desired preset
station is found.
2
1
1
2