Teac AG-620 - Page 8

@ AM Outdoor Antenna
If the AM loop antenna provided does not provide
sufficiently good reception (because you are too far
from the transmitter or in a concrete building, etc.), it
may be necessary to use an outdoor AM antenna.
Use an insulated wire more than 15 ft (5 m) long, strip
one end, and connect this to the terminal shown. The
antenna wire should be strung outdoors or indoors
near a window. For better reception, connect the
GND terminal to a reliable ground.
Note: Even when using an outdoor AM antenna, do
not disconnect the AM loop antenna.
AM Outdoor Antenna
AM Loop Antenna
(provided)
SSS
Caution:
To avoid damaging the speakers by inputting a
sudden high level signal, before connecting the
speakers, be sure to switch the power off.
Connect the main pair of the speakers to the
SPEAKERS A terminals, and connect the second pair
to the SPEAKERS B terminals.
Connect the speaker cords to the speaker terminals as
shown in the following illustration.
Press the lever, insert the stripped end of the
cord, then release the lever so that the cord is
held securely.