OSD Menu
2. PICTURE menu
Description
Picture Mode: There are four preset settings to choose from: Standard, Dynamic, User and Mild.
Note: Contrast, Brightness, Colour and Sharpness in the Picture Mode settings can only
be adjusted and saved while in User Mode.
Contrast: Adjust the difference between the brightest and darkest regions of the picture.
Brightness: Adjust the overall brightness of the picture.
Colour: Control the colour.
Sharpness: Increase this setting to see Sharp edges in the picture; decrease it for softer edges.
Tint: Controls the tint ( NTSC mode only).
Colour Temperature: Choose from Medium, Cool, User and Warm.
Choose from Video, PC.
Red: Controls the red colour of the picture.
Green: Controls the green colour of the picture.
Blue: Controls the blue colour of the picture.
Aspect Ratio: Choose from 4:3, 16:9, Zoom1, Zoom2, Panorama.
Note: Different aspect ratios are available depending on the input source.
Noise Reduction: Choose interference noise modes: Off, Low, Middle, High.
Screen(PC mode only):
Over Scan(HDMI mode only):
Press OK to enter the submenu to adjust the
Horizontal / Vertical
position, Size or Phase of the picture.
Picture display settings can be altered as desired. The following options are adjustable:
16
OSD Menu
Multimedia
Operation
Recording
Operation
Maintenance
and Service
To Next Page
Loading...
