10
K
MONITOR OUT connector
This can be used to output a monitor signal, which can be the
input signal of any channel or the voice memos.
L
SDHC card slot
Insert SDHC cards here.
M
RDX cartridge emergency ejection hole
Use if you cannot eject the RDX cartridge with the EJECT
button.
N
RDX cartridge dock
Load RDX cartridges here.
O
RDX cartridge EJECT button and indicator
Use to eject RDX cartridges.
The indicator shows the status as follows.
Indicator Meaning Explanation
Unlit No power
No power is being supplied to
the RDX docking station.
Lit green Ready
Power is being supplied to the
RDX docking station and it is
functioning properly.
Blinking
green
Ejecting
The cartridge is being ejected
from the docking station.
Lit yellow Malfunction-ing
A malfunction has been
detected in the RDX docking
station.
Blinking
yellow
Ready
The RDX media was being
accessed when you pressed
the EJECT button. After blink-
ing yellow for a few seconds,
it will light green.
P
LEVEL LEDs
Each LED lights green when its input level exceeds 10% of
its input range and lights red when it exceeds 115%. When
using an ICP sensor, the LED lights yellow when there is no ICP
current.
Q
Input connectors
Use these to input measurement signals.
4. Names and Functions of Parts
To Next Page
Loading...
Need help?
General
