TEC MA-1350-1 Series Programming Manual

- 45 -
EO3-11084
MA-1350-1 SERIES
Address : 2 1
(Optional Function 7)
7
▼
Your Selection
▼
Supplementary Description for Address 21:
Bit 1: IPD................................ Items Printed in Details
INPD ............................. Items not Printed in Details (Department/PLU item Entry except
Returned Merchandise, Item Correct, Negative Department/PLU,
Void and All Void will not be printed on Journal.
Bit 2: SET status: ................... An error will result when the drawer is kept open for the programmed
seconds. Drawer Warning Time “15 seconds” is initially programmed.
• In case that both this bit and Bit 3 (Multi Drawer Spec.) are selected to SET status.
1) When a cashier key is changed after the drawer opens, the drawer open/close condition,
which has been assigned to the changed cashier will be judged.
2) Drawer 1 condition is judged for the cashier keys 1 and 2, and Drawer 2 condition is
judged for the cashier keys 3 and more. Drawer 1 condition is judged during the cashier
key OFF status.
Bit 3: If SET status is selected, Drawer 1 will be assigned to the cashiers 1 and 2, and Drawer 2 to the
cashiers 3 and more.
Initial SET Bit Nos.
1 Sales Detail Items Print on Journal (IPD/INPD)
2 Drawer Warning Spec.
3 Multi Drawer Spec.
4 All Department Report Separate from Daily or GT Financial
Report
5 Decimal Point in Item Count and Rate
6 Decimal Point in Amount (for the “0.00” zero-suppress ver-
sions)
7 Amount Division Symbol between 3rd and 4th for . 0 type
8 Store Name Print by Rubber Stamp or Dot Printer
Content
Bit
No.
Selective Status
RESET
SET
ACTIVE
NON-PRINT
(INPD)
PRINT (IPD)
NON ACTIVE
SEPARATE
ISSUE
2 DRAWERS
SINGLE
DRAWER
PRINT ALONG WITH
AUTO REPORT
, (COMMA)
, (COMMA)
. (POINT)
. (POINT)
DOT PRINTER
, (COMMA)
. (POINT)
RUBBER STAMP

TEC MA-1350-1 Series Specifications

General

Brand	TEC
Model	MA-1350-1 Series
Category	Cash Register
Language	English