4
Revised 08/04
-- Z21.58b/CGA1.6b-2002
4
General Overview
WARNING: THIS GRILL IS DESIGNED CERTIFIED
FOR USE OUTDOORS ONLY.
THIS GRILL SHOULD NOT BE USED IN A BUILDING,
GARAGE OR OTHER ENCLOSED AREA AND IS NOT
INTENDED FOR USE ON RECREATIONAL VEHICLES
OR BOATS.
DO NOT USE THIS APPLIANCE UNDER OVERHEAD
COMBUSTIBLE CONSTRUCTION.
Permanent Installation
The installation of your grill must conform to local codes
or, in absence of local codes, the National Fuel Gas Code
ANSI Z223.1/NFPA 54. In Canada, the installation
must conform to local codes and/or the Natural Gas and
Propane Installation Code CAN/CGA-B149.1.
The Post Base is constructed of stainless steel, which is
highly corrosion resistant. However, a suitable means of
corrosion protection should be used, as necessary, due to
corrosive conditions at the installations site.
If you are installing your grill on the optional In-ground
Post Base or the Bolt-down Post Base, it should be
located so the ventilation louvers remain clear of all
obstructions. The louvers are located in the front surface
of the Grill’s Housing and at the rear of the Roll Back
Hood. Any accumulation of debris will restrict the flow
of combustion and/or ventilation air, and may result in
improper burner operation or overheating. (See Table A.1
for clearance specifications.) Installation procedures
relating to gas connections for permanent installations
can be found in the Gas Connection section of this
manual.
Contents Installation
Installation .......................... 4
Assembly ............................ 5
Gas Connection ...................... 7
Operation ............................ 10
Infra-Red Cooking .................. 13
Care, Cleaning and Maintenance.. 15
Protection of burners
Cleaning
Replacement parts
Heat shield removal procedures
Appendix A - Accessories .......... 17
Appendix B - Replacement Parts .. 23
Appendix C - Troubleshooting...... 24
To Next Page
Loading...
Need help?
General
