10
Revised 08/04
-- Z21.58b/CGA1.6b-2002
General Overview
NOTICE: YOU SHOULD INSPECT THE BURNER
VENTURI TUBES FOR SPIDER WEBS AND OTHER
OBSTRUCTIONS PERIODICALLY. CLEAN TUBES
COMPLETELY IF YOU FIND ANYTHING. A CLOGGED
TUBE CAN LEAD TO A FIRE BENEATH THE GRILL.
NOTICE: NEVER PLACE FOOD OVER A BURNER
THAT IS NOT IN OPERATION. FOOD DRIPPINGS WILL
NOT BE INCINERATED AND THE BURNER PORTS MAY
BECOME CLOGGED. THE BURNER SHOULD NOT
COME IN CONTACT WITH WATER OR OTHER
CLEANING FLUIDS BECAUSE THEY MAY DAMAGE THE
BURNER, CAUSING IT TO FUNCTION IMPROPERLY.
The Patio II™ grill is equipped with a pilot burner. This
safety feature will re-ignite the burner if it goes out while
you are cooking. Pilot burners take a certain amount of
time to ignite because gas must first flow from the gas
cylinder to the pilot tip. When lighting the pilot, be sure
to use the following instructions.
Burner Ignition
Procedure:
1. Open the Hood, ensure all valves are closed and that
the cooking surface of the grill is not covered.
2. For LP gas, open the Gas Cylinder Valve by turning
the Handwheel counter-clockwise. (See Figure 8.)
Then, wait 15 seconds prior to Step 3.
For Natural gas, open the gas valve in the main line.
3. Depress and turn the Pilot Output Knob to (ON).
.
4. Slowly rotate the Ignitor Knob clockwise twice and
check for pilot flame. If a flame is not present, turn
the Pilot Output Knob to OFF and wait 5 minutes.
Then repeat steps 3 and 4.
5. Depress and turn the Burner Output Knobs to
(HIGH).If burners do not ignite within 5 seconds,
turn Burner Output Knobs to OFF and wait 5
minutes, and repeat.
6. Operate on (HIGH) until burners glow uniformly,
then turn the Burner Output Knobs to the desired
cooking level.
7. To extinguish the flame, depress and rotate the Burner
Output Knobs and the Pilot Output Knob to OFF.
8. For LP gas, close the Gas Cylinder Valve by turning
the Handwheel clockwise. For Natural gas, close the
gas valve in the main line.
CAUTION: WITH THE HOOD CLOSED, THE BURNER
OUTPUT KNOB POSITION MARKED
*
IS THE MAXIMUM
TEMPERATURE SETTING TO BE USED. THE BURNER
OUTPUT SHOULD NEVER BE INCREASED BEYOND THIS
POSITION WITH THE HOOD CLOSED.
Burner Ignition Without Pilot
If your pilot/spark ignition system is not working properly, the
burner may be ignited manually, using a match. Use the
following procedure to do so.
CAUTION: DO NOT HOLD A MATCH IN YOUR HAND
ABOVE THE SCREEN WHEN LIGHTING THE BURNER
MANUALLY. PLACE THE MATCH DIRECTLY ON THE
BURNER SCREEN, THEN PULL YOUR HAND AWAY FROM
THE GRILL..
Operation
To Next Page
Loading...
