UK
10
detailed product information.
▶ Weights: net-gross-tare.
▶ Dimensions: length-width- height.
▶ Hoisting hook-up points.
3
1
3
2
4
1 Cardboard packaging
2 Straps (secure the packaging to the pallet)
3 Pallet - Fork side
4 Table of weights and handling dimensions
3.4 STORAGE
Temporary or extended storage must be done in indoor areas
protected from atmospheric agents.
The display cases must be handled with care.
4
Proceed as follows for the unloading, transport and unpacking
operations.
3.5 UNLOADING OPERATIONS
The orientation of the packed display case must comply with
the indications listed on the pictogram and the writing on the
outside package.
Conduct the unloading operations using suitable hoisting
equipment (the capacity must be adequate for the weight of
the acked display case), hoisting it as shown in Fig 5.
5
3.6 CHECKING THE SUPPLY
Before taking delivery from the shipper, check
the conditions of the packing.
lf it shows obvious damage on the outside, the display case
could be damaged.
In this case, unpack the display case in the shipper’s presence.
Any damage caused by incorrect handling and storage is not
the manufacturer’s responsibility.
IN THIS CASE:
▶ A) Contact your area representative
▶ B) Draw up a written report
▶ C) Send a copy of the report to the manufacturer or area
representative.
3.7 HANDING THE DISPLAY CASE
The display case can be lifted with a fork-lift truck or with
any other suitable means with a minimum capacity of twice
the weight of the display case (see the specific nameplate).
To Next Page
