UK
15
4.3 PREPARATION FOR OPERATION
4.3.1 Preliminary checks
Check that the following have been removed
on and near the machine: packaging materials,
remaining parts of the screw kit, tools.
4.3.2 Cleaning
Clean the surfaces (glass, inner tray, ice cream
tubs) with neutral (non-aggressive) materials
and wipe with a dry cloth.
The following are forbidden:
▶ wash the appliance with direct water jets;
▶ use chemical solvents, flammable or ag-
gressive liquids.
4.4 ELECTRICAL CONNECTION
The display case must be connected to a plug with an omni-
polar switch upstream to ensure disconnection from the power
mains. The minimum opening distance of the contacts must
be at least 3 mm, sized far the load and compliant with the
regulations currently in force.
▶ Do not place the power cable in a transit area. We also
recommend protecting the cable with trunking anchored
to the floor.
▶ NEVER touch the power plug if your hands are wet.
▶ Verify that the power mains network is earthed in
accordance with the regulations in farce.
19
▶ NEVER insert any adapters or multiple plugs on the
supply plug used to connect the display case.
▶ NEVER use extensions to connect the display case to the
mains.
▶ Verify that the mains voltage complies with the data listed
on the nameplate of the machine (maximum allowable
variation ±6 %).
▶ Do not place the machine on floors that are usually wet.
▶ Do not tug the power cord to disconnect it from the
power supply.
ELECTRICAL CONNECTION TO THE GRID
▶ Connect the power cord plug of the machine to the wall
outlet in the installation room.
CAUTION!
The power cord must not be crushed in any
way and must be kept in good condition.
CAUTION!
The plug must always be easily accessible so
that it can be disconnected.
To Next Page
