Tech4o Traileader - Dual Time Mode; Dual Time Zone Display; Dual Time Zone Setting; Speed & Distance Mode

15
* Press ST/STP(+) or LAP/RST( - )
to adjust the hour
* Press M to confirm your selection
* Press ST/STP(+) or LAP/RST( - )
to adjust the minutes
* Press ESC to confirm your selection
TRAIL MEnu FunCTIOnS
The following 4 sections (6-Speed &
Distance, 7-Altimeter, 8-Barometer,
9-Compass) are all TRAIL MENU
functions.
The previous 5 sections (1-Time/Date,
2-Alarm, 3-Chronograph, 4-Countdown
Timer, 5-Dual Time) were TIME MENU
functions. Understanding which
functions are in which menu and how
to switch between menus is crucial to
navigating your new Traileader. To access
a function in a different menu than the
watch is currently in, remember to —
press ESC twice to toggle between
menus.
6.0 SPEED & DISTAnCE MODE
The TraiLeader’s Speed & Distance mode
uses accelerator technology to accurately
track your: Speed, Distance, Pace,
Calories, and Steps on the road, trail or
treadmill.
Note: Although your Traileader came
pre-programmed with a generic profile,
it is highly recommended that you take
5 minutes to properly calibrate Speed &
Distance mode to your personal profile
in order to obtain the most accurate
results. See section 6.3
6.1 SPEED & DISTAnCE MODE DISPLAy
To access Speed & Distance display while
currently in a:
TRAIL MEnu function - continue
pressing M until the display in fig. 13
is visible
TIME MEnu function - press ESC twice
to access the Trail Menu and press ST/
STP(uP) or LAP/RST(DOwn) to ¬
TRaIl mEnu