Tech4o Traileader - Adjust Sensitivity of the Accelerometer; Adjust My Weight

19
Access the Speed & Distance Display (See
section 6.1 for how to access the Speed &
Distance display)
• Hold M for 3 seconds to enter Speed &
Distance set menu
• Press LAP/RST(DOwn) to scroll to Sleep
• Press M to select the Sleep
* Press ST/STP(+) or LAP/RST( - )
to adjust the sleep timer for Speed &
Distance mode
* Press ESC to confirm your selection and
exit Sleep
• Press ESC to exit Speed & Distance set menu
6.8 ADJuST THE SEnSITIVITy OF
THE ACCELEROMETER
The sensors and software that measure
movement in Speed & Distance mode
are adjustable. In nearly all cases, level
1 (least sensitive) is ideal for most users
and will produce the most accurate
results. If you have a very gentle/smooth
gate, a more sensitive setting may be
necessary.
Note: A discrepancy in actual distance
walked and the distance measured by the
Traileader is not usually a sensitivity issue
but rather an adjustment needed to the
stride lengths. The exception to this rule
is when a “normal” user has entered a
higher sensitivity than is necessary.
Access the Speed & Distance Display (See
section 6.1 for how to access the Speed &
Distance display)
• Hold M for 3 seconds to enter Speed &
Distance set menu
• Press LAP/RST(down) to scroll to Sense
• Press M to select the Sense
* Press the ST/STP(+) or LAP/RST( - )
to adjust the sensitivity level of Speed
& Distance mode (1 = lease sensitive
to 7 = most sensitive)
* Press ESC to confirm your selection and
exit Sense
• Press ESC to exit Speed & Distance set menu
6.9 ADJuST My wEIGHT
Access the Speed & Distance Display (See ¬
SPEED & DISTanCE