Tech4o Traileader - Clear Ascent;Descent Calculator; Set Altitude Alarm; View Altimeter Log Book

24
7.6 CLEAR THE ASCEnT/DESCEnT (AS/DS)
CALCuLATOR
Access the Altimeter Display (See section 7.1 for
how to access the Altimeter display)
• Hold M for 3 seconds to enter Altimeter set menu
• Press LAP/RST(DOwn) to scroll to AS/DS
* Press LAP/RST(DOwn) to scroll to Clear
* Press M to select Clear
* Press ST/STP to clear the ascent/descent
calculator and exit Clear
• Press ESC to exit AS/DS
• Press ESC to exit Altimeter set menu
7.7 SET An ALTITuDE ALARM
Access the Altimeter Display (See section 7.1 for
how to access the Altimeter display)
• Hold M for 3 seconds to enter Altimeter set menu
• Press LAP/RST(DOwn) to scroll to Alt. Alm.
• Press M to select Alt. Alm.
* Press ST/STP to toggle between the two
altitude alarms
* Press LAP/RST to toggle altitude alarm on
and off
• Hold M for 3 seconds to enter an alarm altitude
* Press ST/STP(+) or LAP/RST( - ) to
adjust the alarm altitude
* Press M to confirm
* Press ST/STP to toggle between Alt. Dif
and Cur. Alt.
* Alt. Dif. will sound the alarm when
the altitude difference calculator
exceeds or drops below the alarm
value
* Cur. Alt. will sound when the current
altitude exceeds or drops below the
alarm value
* Press ESC to confirm
Press ESC to cancel and exit Alt Alm
Press ESC to exit Altimeter set menu
Note: The altitude alarm will not sound
if you exit the altimeter mode.
7.8 VIEw THE ALTIMETER LOG BOOK
The Traileader’s altimeter contains a logbook
that tracks maximum and minimum
altitude readings over the past 48 hours,
as well as, an hourly time stamped
altitude reading for the last 48 hours.