Tech4o Traileader - View Barometer Log Book; Switch Among INHG, MB, & HPA

28
BAROMETER SETTInG See fig.18
8.2 CHAnGE THE SEA LEVEL PRESSuRE
MEASuREMEnT
ALTHOUGH IT’S POSSIBLE TO PERFORM
THIS STEP, WE RECOMMEND THAT YOU
DO NOT MAKE THESE CHANGES.
Access the Barometer Display (See section 8.1
for how to access the Barometer display)
• Hold M for 3 seconds to enter Barometer
set menu
• Press M to select SLP
* Press ST/STP or LAP/RST to adjust
the Seal Level Pressure to match your
current, known Sea Level Pressure
* Press ESC to confirm and exit SLP
• Press ESC to exit Barometer set menu
8.3 CHAnGE THE CuRREnT PRESSuRE
MEASuREMEnT
ALTHOUGH IT’S POSSIBLE TO PERFORM
THIS STEP, WE RECOMMEND THAT YOU
DO NOT MAKE THESE CHANGES.
Access the Barometer Display (See section 8.1
for how to access the Barometer display)
• Hold M for 3 seconds to enter Barometer
set menu
• Press LAP/RST(DOwn) to scroll to Cur.
Pres.
• Press M to select Cur. Pres.
* Press ST/STP or LAP/RST to adjust the
pressure to match your current, known
pressure
* Press ESC to confirm and exit Cur. Pres.
• Press ESC to exit Barometer set menu
8.4 VIEw THE BAROMETER LOG BOOK
The Traileader’s Barometer contains a
logbook that tracks the maximum and
minimum pressure and temperature
readings over the last 48 hours, as well
as, an hourly time stamped altitude
reading for the last 48 hours.
Access the Barometer Display (See section 8.1
for how to access the Barometer display)
• Hold M for 3 seconds to enter Barometer set
menu ¬