TABLE OF CONTENTS
1. Introduction 1
2. Description 1
3. Features 1
4. Unpacking 1
5. Installation 2
5.1 Environment 2
5.2 Power Options 2
5.3 Battery Installation 2
5.4 AC Adapter 3
6. Operation 3
6.1 Turning The Balance On And Off 3
6.2 Checking Calibration 3
6.3 Weighing 4
6.4 Units exchange 4
6.5 Taring 4
6.6 Parts Counting 4
7. Using Menus To Configure The Balance 5
7.1 Calibration Menu 6
7.2. Calibration Menu Protection 7
7.3 Calibration Masses 7
8. Setup Menu 7
8.1 Accessing The Setup Menu 8
8.2 Accessing The Submenus In The Setup 8
8.3 Reset To Factory Settings 8
8.4 Unit Selection 8
8.5 Taels 9
8.6 Stability Range 10
8.7 Auto―Zero 10
8.8 Parts Counting Error Level 11
8.9 Auto―Off 11
8.10 End 11
9. Calibration Lock―Out Protection 11
10. Care And Maintenance 12
11. Troubleshooting 12
12. Error Codes 12
Err 1 Sample being weighed exceeds the capacity of the balance. If
error occurs when the sample is within the balance capacity,
balance may be incorrectly calibrated.
To Next Page
Loading...