→ Simple Restore: Every setting will be reset
except the camera and the network settings.
→ Restore All: All configurations are restored.
Monitor is set back to factory settings. Camera
need to add again by Match Code.
Change the password. Enter the current used
password (old password). Than enter two times the
new password you want to use from now on to
login on the Security Premium App.
→ Local Upgrade: If there is a new firmware
available on our homepage
www.technaxx.de/support under Security
Premium. Copy it to an empty USB stick max.
32GB and insert it to the USB port of the monitor.
After that choose local Upgrade to update the
firmware.
→ Logo: Not supported
→ Channel Logo: not supported
→ Info: Shows you the current installed firmware
on the camera.
→ Channel: Choose the camera channels you
want to upgrade.
→ Source: Here is only local upgrade available. If
there is a new firmware available on our homepage
www.technaxx.de/support under Security
Premium. Copy it to an empty USB stick max.
32GB and insert it to the USB port of the monitor.
Allow downgrade: Enable/disable to allow a
downgrade to an older firmware version.
If you have done the above steps press Start.
To Next Page
Loading...
Need help?
General
